SIG SAUER BUCKMASTERS 1-Inch Low Scope Ring Set

Description

SIG SAUER BUCKMASTERS 1-Inch Low Scope Ring Set

Mount a 1-inch riflescope in a compact, low-profile position with the SIG SAUER BUCKMASTERS Low Scope Ring Set. This exact pair, manufacturer part SOA10033, is designed for scopes with a 1-inch main tube and rifles equipped with an M1913 Picatinny rail. The low 0.85-inch centerline height helps keep the optic close to the rifle when the objective bell, receiver, and barrel profile provide sufficient clearance.

SIG SAUER machines these BUCKMASTERS hunting rings from 6061-T6 aluminum. The material provides a useful balance of strength and manageable weight, while the black anodized finish adds surface protection and a subdued appearance. The rings are supplied as a matched pair and use a 0 MOA configuration, making them a straightforward choice for hunting rifles and general-purpose optics setups that do not require built-in elevation cant.

Low-Profile Mounting

Keeping a scope lower can support a more natural cheek weld and consistent head position, but only when the complete rifle-and-optic combination allows it. The published 0.85-inch height is measured from the top of the Picatinny rail to the centerline of the optic. Before ordering, compare that measurement with the scope’s objective diameter, any lens cap or cover, the rifle’s barrel contour, receiver shape, and rail position.

These rings are intended for a 1-inch scope tube. They are not interchangeable with 30mm or 34mm rings, and they should only be mounted to a compatible Picatinny-style rail. Confirm both the tube diameter and rail specification before installation.

Key Features

• Matched two-ring set
• Designed for 1-inch riflescope tubes
• Low 0.85-inch centerline height
• Compatible with M1913 Picatinny rails
• 6061-T6 aluminum construction
• Black anodized finish
• 0 MOA cant
• Manufacturer part number: SOA10033
• UPC: 798681662548

Installation Guidance

Proper ring installation protects the optic and helps the rifle maintain zero. Begin with an unloaded firearm in a stable work area. Clean the rail and ring interfaces, position the lower ring halves so the scope has adequate support and adjustment room, and confirm that the rings seat fully in the Picatinny slots. Set eye relief with the rifle shouldered naturally before final tightening.

Level the rifle and reticle, then tighten the base and cap screws gradually in an alternating pattern. Maintain even spacing between the upper and lower ring halves. Use the torque values supplied by SIG SAUER, the optic manufacturer, and the firearm or rail manufacturer; excessive torque can damage the scope tube or fasteners. After installation, verify objective clearance, bolt or charging-handle access, and unobstructed control movement.

Recheck mounting hardware after the initial range session and inspect it periodically as part of routine firearm maintenance. The BUCKMASTERS SOA10033 ring set is a practical mounting solution for shooters who need a lightweight, low-position pair of rings for a 1-inch optic and Picatinny rail.