SIG SAUER ALPHA1 35mm High Scope Rings

SIG SAUER ALPHA1 35mm High Scope Rings

Build a solid optic interface with the SIG SAUER ALPHA1 35mm high-profile scope-ring set. Identified by manufacturer part number SOA10024 and UPC 798681616503, this complete two-ring set is sized for riflescopes with a 35mm main tube and is designed to attach to a Mil-Spec 1913 Picatinny rail.

SIG’s ALPHA1 hunting rings are precision machined from aluminum to balance strength with practical field weight. This version uses a matte black finish and a 1.25-inch high profile, providing additional clearance for optic objectives, rail components, or rifle configurations that require a taller mounting position. The 35mm diameter is less common than 30mm or 34mm, so matching the ring size to the scope’s actual main-tube diameter is essential.

Key Features

• Ring diameter: 35mm
• Profile: High, 1.25 inches
• Material: Precision-machined aluminum
• Finish: Matte black
• Rail interface: Mil-Spec 1913 Picatinny
• Set: Complete pair of scope rings
• Manufacturer part number: SOA10024
• UPC: 798681616503

Purpose-Built for 35mm Optics

The correct rings do more than hold a scope in place: they establish the optic’s height, alignment, and relationship to the rifle. These ALPHA1 rings are intended specifically for a 35mm main tube, helping avoid the fit problems that come from using the wrong diameter. The high configuration can be useful when a larger objective bell needs extra room above the barrel or handguard, or when the rifle’s comb and shooting position work best with a taller optic centerline.

Because “high” is not standardized across every ring maker, use the published 1.25-inch profile as the meaningful comparison point. Before installation, confirm the scope tube diameter, objective clearance, rail type, and the height needed for a comfortable cheek weld. These rings are for Picatinny-style rails; they are not a direct fit for traditional dovetail or proprietary receiver mounting systems without the appropriate base.

Installation and Setup

Install the rings on an unloaded firearm in accordance with the rifle, scope, and ring manufacturers’ instructions. Position the scope to obtain proper eye relief, level the reticle, and tighten all fasteners evenly with an appropriate torque tool. Do not substitute a generic torque value: follow the current SIG SAUER instructions supplied with the rings and the optic manufacturer’s limits for ring-cap screws. Excessive torque can damage an optic tube, while uneven tightening can affect alignment.

After installation, verify clearance throughout the firearm’s normal operation, confirm that the optic remains secure, and recheck fasteners after the initial range session. The ALPHA1 35mm high ring set is a focused choice for shooters who need a genuine SIG mounting solution with a specific 35mm diameter and 1.25-inch profile.