SIG SAUER ALPHA6 34mm Extra-High Scope Rings

Description

SIG SAUER ALPHA6 34mm Extra-High Scope Rings

Mount a compatible 34mm riflescope with a factory SIG SAUER ALPHA6 ring set designed for MIL-STD-1913 Picatinny rails. Manufacturer part number SOA64004 is the extra-high, 1.25-inch profile in matte black. The matched pair is machined from 6061-T6 aluminum alloy to provide a strong mounting interface without adding unnecessary weight to the rifle.

Designed for 34mm scope tubes

These rings are made specifically for a 34mm main tube. Tube diameter must match exactly: they are not intended for one-inch, 30mm, or 35mm optics. The extra-high profile can provide additional clearance for a larger objective bell, tall rail, receiver geometry, or accessories mounted near the optic. The required height depends on the rifle, base, objective diameter, barrel contour, and desired cheek position, so measurements should be confirmed before ordering.

Picatinny mounting interface

The ALPHA6 rings attach to a compatible MIL-STD-1913 Picatinny rail. Both rings should seat fully and squarely on the same rigid base whenever possible. Proper ring spacing supports the scope without contacting the turret housing, magnification controls, or curved portions of the tube. A scope should never be forced into rings that are misaligned or spaced outside the manufacturer’s permitted mounting area.

Correct installation is essential for protecting the optic and maintaining zero. Follow SIG SAUER’s current instructions for base and cap-screw torque rather than using a generic value. Tighten cap screws gradually and evenly so the gap remains balanced from side to side. Excessive torque can deform the scope tube or damage internal components, while insufficient torque can allow the optic to shift under recoil.

Setup checklist

• Confirm the riflescope has a 34mm main tube.
• Verify that the rifle or base uses a compatible Picatinny rail.
• Measure objective and accessory clearance before selecting the extra-high profile.
• Establish comfortable eye relief from the normal shooting position.
• Level the reticle before applying final torque.
• Use an inch-pound torque driver and the current manufacturer specifications.
• Recheck mounting security and zero after initial use or a hard impact.

The matte black finish coordinates with common rifle and optic finishes while limiting glare. Aluminum construction also helps keep the total mounting system manageable on hunting, target, and general-purpose rifle setups.

This listing includes one pair of rings. A riflescope, rail, firearm, tools, level, and thread-locking compound are not included. Do not apply adhesives unless the optic or ring manufacturer specifically directs their use.

Key specifications

• Manufacturer: SIG SAUER
• Manufacturer part number: SOA64004
• UPC: 798681694266
• Series: ALPHA6
• Tube diameter: 34mm
• Profile: Extra high, 1.25 inches
• Material: 6061-T6 aluminum alloy
• Rail interface: MIL-STD-1913 Picatinny
• Finish: Matte black
• Quantity: Two rings